Xylem MultiLab 4010-2 Manual do Utilizador descarregar pdf (Página 74)

Settings MultiLab 4010-2

74 ba76142e01 05/2013

Dissolved oxygen The following settings for D.O. measurements are reset to the default settings

with the Reset function:

The sensor settings are reset under the Reset menu item in the menu for cali-

bration and measurement settings. To open the settings, display the required

measured parameter in the measured value display and press the <ENTER>

key.

Conductivity The following settings for conductivity measurements are reset to the default

settings with the Reset function:

The sensor settings are reset under the Reset menu item in the menu for cali-

bration and measurement settings. To open the settings, display the required

measured parameter in the measured value display and press the <ENTER>

key.

Setting Default settings

Calibration interval 180 d

Check interval 60 d

Measured parameter D.O. concentration

Relative slope (S

Rel

) 1.00

Salinity (value) 0.0

Salinity (function) Off

Setting Default settings

Calibration interval 150 d

Measured parameter

Cell constant (c) Depending on the connected mea-

suring cell:

0.475 cm

-1

(calibrated)

0.475 cm

-1

(set)

0.100 cm

-1

Temperature compensation nLF

Reference temperature 25 °C

Temperature coefficient (TC) of the

linear temperature compensation

2.000 %/K

Multiplier for TDS 1.00

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 111 112

Sem comentários

Xylem MultiLab 4010-2 Manual do Utilizador Página 74