Xylem O&M Mini V Series Variable Speed Manual do Utilizador descarregar pdf

Operating and Maintenance Instructions

Declaration of conformity

Lowara pumps UK declare that the Mini V Booster set conforms to the requirements of the Machinery Safety

Directive 98/37/EEC.

Conforming to the UK Health & Safety Requirements S.I. 1992 No 3073 S.I. 1994 No 2063

Water supply (Water fittings) regulations 1999

Simple pressure vessel directive 87/404/EEC

Signed: Position: Engineering manager Date: 27-02-12 Revision

Clive Willmott

Introduction

This leaflet contains information to enable the safe installation and operation of the products mentioned.

The following instructions must be read and understood by all persons responsible for the installation,

operation and maintenance of this product.

Warning Symbols

Safety instructions where noncompliance would affect safety.

Safety instruction where electrical hazard is involved.

Safety instruction where noncompliance could cause damage to the equipment.

Instruction for safe us

This product has been designed for boosting cold water in potable water installations to the

operating conditions shown.

This product should not be installed until this leaflet has been studied carefully and understood.

Handling, transportation and installation of this equipment should only take place with the proper

use of lifting equipment. This product must be stored in a frost-free dry environment.

Noise Emission

This equipment operates at a noise level lower than 70dBA.

Operating limits

Fluid temperature 0°C to 40°C

Ambient temperature 0°C to 40°C

Operating pressure Max 5 Bar

Protection class Teknospeed & Electrical panel IP55

Mini V 1-2 Pump Cold Water Booster

Sets TKS/GTKS Variable Speed

mini V booster set o and m instructions:Layout 1 11/05/2012 15:19 Page 1

1 2 3 4 5 6

Resumo do Conteúdo

Página 1 - Sets TKS/GTKS Variable Speed

Operating and Maintenance InstructionsDeclaration of conformityLowara pumps UK declare that the Mini V Booster set conforms to the requirements of th

Página 2

InstallationThe cold Water booster set is despatched mounted on a wooden pallet and covered in a protective film, it isrecommended that the unit be re

Página 3

Discharge pipe workfitted to the end not used. A flexible connector fitted between the booster discharge manifold and the systemconnection pipe will h

Página 4

4OperationThe booster set is designed to maintain a constant system pressure with varying flows.Each inverter head has its own 4-20ma transducer which

Página 5 - Fault Possible Cause Remedy

CautionThis booster set is an automatic machine; the pumps may start up automatically withoutprior warning.The set contains pressurised water; reduce

Página 6 - Lowara UK Limited

6DisposalDisposal of this product should be carried out in accordance of local codes and regulation pertaining to thedisposal of waste, including pack