INSTRUCTION MANUALMM-616)Series FS-5General PurposeLiquid Flow Switch®
2Motor Switch Rating (Amperes)Voltage Full Load Locked Rotor Pilot Duty120 VAC7.4 44.4125 VA at240 VAC 3.7 22.2120 or 240 VAC50 or 60 cyclesMaximum Li
FLOW RATESSettings will vary when used to sense flow of otherfluids.3NOTE: DO NOT USE LIQUID FLOWSWITCHES ON SYSTEMS WITHFLOW VELOCITY GREATER THAN10
4SECTION 2 - Connecting the Flow Switch to Pipeb. Insert pipe threads into flow switch and turn 2 or 3 times until tight.• Place one pipe wrench on he
5Aa. Cover Removal and Installation Procedure• Using a flathead screwdriver, loosen but do not removethe two cover screws and remove the cover (A).• P
6d. Based upon the mode of operation (“Flow”or “No-Flow”) required, complete the appropriate steps to connect wires to flow switch. Use a Phillip’s he
7a. Place cover on flow switch and turn on power. Initiate fluid flow through the system. Observe the device being activated by the flow switch to det
Xylem Inc. 8200 N. Austin Avenue Morton Grove, Illinois 60053 Phone: (847) 966-3700 Fax: (847) 965-8379www.mcdonnellmiller.comMcDonnell & Miller i
Comentários a estes Manuais