Xylem MOH2 Multi zone mixing module (obsolete) Manual do Utilizador descarregar pdf (Página 9)

Installation and operation manual MOH2

www.lainginc.com

Angled installation

The picture below shows the angled installation with the mounting

hardware attached accordingly

• Use the 0.8‘‘ (20 mm) and the 0.87‘‘ (22 mm) spacer at the upper

mounting eyelet

• Use the 0.2‘‘ (5 mm) spacer at the lower mounting eyelet

• Turn the rubber grommets in such a way that they are parallel to the

wall.

• Fix the manifold by attaching the side of the mounting bracket with the

small hole spacing to the manifold.

If you purchased the base module without manifold

• Attach the manifold [see previous chapter]

• Install the station directly on the wall or in a sufficiently large cabinet

• Use the two eyelets of the base module for installation

• Use the spacers, the grommets and the washers.

• In addition, attach the manifolds. (For the Laing segmented plastic

manifold, special attachment hardware is available)

Important advice for avoiding noise problems

• Avoid any metal contact between the base module and the wall

• Avoid any metal contact between the manifold and the wall

• Use rubber grommets at all mounting points on both sides to avoid

metal contact between the mounting screws and base module or

manifold [the rubber grommets and washers for the mounting eyelets

of the MOH2 are supplied with the station].

Grommet Mounting

bracket

[large hole spacing]

Spacer 20 mm

Spacer 22 mm

Spacer 5 mm

Grommet

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Sem comentários

Xylem MOH2 Multi zone mixing module (obsolete) Manual do Utilizador Página 9