Xylem STORM 3 Getting Started Guide Manual do Utilizador

Storm 3GETTING STARTED GUIDEV.2.0

CONNECT TO THE STORM 3802 /LED IndicatorsUSB Wi-Fi ConnectionUSB Cable Connection

9The Storm 3 contains a built-in graphical user interface, accessible by either a Wi-Fi or cable connection. No special software is needed to access

USB CONNECTION10Note: The user interface will be displayed on only one hardware connection (Wi-Fi or USB device cable) at a time. The USB Wi-Fi conne

Connect To The Storm 3USB Device Cable ConnectionTo connect directly to the Storm data logger, the supplied USB device cable can be used. The first us

12USER INTERFACE03 /Home Page NavigationSet Date & TimeAdding & Configuring SensorsEnabling ScanningDownload Data

User Interface13Once connected to the Storm 3 data logger, the above interface will become available within a web browser. The interface is divided in

15SENSORSAdding & Configuring SensorsThe Storm 3 data logger uses a set of sensor libraries to quickly and easily configure the system. Sensors can

16User InterfaceAfter setting up each sensor and enabling the desired output options, scanning should be enabled to begin the measurement and data col

Xylem—WaterLOG95 West 100 SouthSuite 150Logan, UT 84321 USATel: +1.435.753.2212Email: [email protected]: www.waterlog.com©2014

This guide is a brief overview of the Storm 3 data logger and its basic features. Additional communication options that can be connected to the Storm

CONTENTSGet to Know Your Storm 3...2 What’s in the Box...3 Har

2GET TO KNOW YOUR STORM 301 /What’s in the BoxHardware: Left SideHardware: Right Side

When unpacking your Storm 3, make sure all the components ordered are received and undamaged from shipping. The basic package includes the following:S

HARDWARELEFT SIDE CONNECTIONS4

AnalogThere are four analog input channels labeled Vin1 to Vin4. They are grouped in sets of two with each set having a common ground and +5Vref termi

HARDWARERIGHT SIDE CONNECTIONS6

Getting To Know Storm 3Digital I/OThe Digital I/O connections can be configured independently as inputs or outputs. In input mode, the signal has an in